axxessinterface.com 800.221.0932
4) If you have a different radio then Eclipse, press the Volume Up button again till the led goes solid
red, then release Volume Up. You have now programmed Kenwood.
5) Here is the chart to show how many presses of the Volume Up button is needed for which radio
you are trying to program:
1stledashisforEclipse
2ndledashisforKenwood
3rdledashisforClarion
4thledashisforSonyandDual
5thledashisforJVC
6thledashisforPioneerandJensen
7thledashisforAlpine*
8thledashisforVisteon
9thledashisforValor
*Note:IftheASWCashes7timesandyoudonothaveanAlpineradioconnectedtoitthatmeans
that the ASWC did not see any radio connected. Verify the 3.5mm connector is connected to the
SWC input on the radio.
6) Once the radio manufacturer has been selected hold Volume Down for at least 5 seconds. The
ledwillashthenumberoftimeswhichradiowasselectedthentheledwillremainontoindicate
theASCWhasnishedprogramming.
7) Go enjoy your radio.
Remapping the SWC Buttons
Let’s say you have the ASWC programmed to your vehicle and your radio and you want to change
the button assignment for the steering wheel controls. For instance you would like Seek Up to be
Mute.
This process is the same as manually programming the ASWC (please refer to the Manual Program-
ming section) with a couple of notes:
•TheASWCmusthavedetectedthevehicleandradioitisattachedtobeforeyoucanremap
any buttons.
•Youcanonlystarttheremappingofthesteeringwheelcontrolsprocesswithintherst20seconds
of turning the ignition key on. If you wait longer then the 20 seconds you will have to turn the
ignition off then back on again.
•Withintherst20secondsifanybuttonotherthenVolumeUporVolumeDownispushed,the
remapping process will stop.
•Ifduringtheremappingprocessnobuttonispushedfor30secondstheremappingprocessis
aborted and the original settings are reset.
Comments to this Manuals